duTec I/O PLEXER Hardware Manual - Communication Wiring

[ Home ] [ Products ] [ Data Sheets ] [ Support ] [ FAQ ] [ Sales Offices ] [ Request Catalog ] [ Contact duTec ]

I/O PLEXER

Communication Wiring

Adding Digital Expanders:

IOP-AD/3+ and Digital Expanders

Figure 2-15 Digital Expanders

Up to three Digital Expanders may be connected to any I/O PLEXER which is equipped with a "/3+" option (click here for information). These chassis are attached to the main unit via a ribbon cable supplied with the Digital Expander. Normally, power is supplied through this cable. In some circumstances, however, the Digital Expander is purchased with an optional power supply. If so equipped, the installer must provide the necessary power connections as well (see Digital Expanders).

Digital Expanders are configured during the main chassis' normal setup procedure (see Chapter 3 - Setup ).

Continue to Chapter 3

Back to Chapter 2a

duTec
6979 Wales Road
Northwood, OH 43619 800-248-1632 Phone
419-666-4700 Phone
419-666-4702 Fax

Top of Page

[ Home ] [ Products ] [ Data Sheets ] [ Support ] [ FAQ ] [ Request Catalog ] [ Sales Offices ]